1·In the heat treatment process, no collision between the workpiece and balanced by furnace heating, plus under the influence of controlled atmosphere to prevent air entering the furnace.
在热处理的过程中，工件相互间无碰撞，均衡的通过炉膛加热，加上可控气氛的作用下，阻止空气进入炉内。
2·The fuel used for heating is either furnace gas or coke oven gas. Thecombustion air is always preheated to improve fuel utilization.
用来加热的燃料不是高炉煤气就是焦炉煤气。燃烧用风通常要预热，以提高燃料的利用率。
3·The results show that the hardness and strength of the work piece after surface quenching protected by process tackling by means of air resistance furnace heating are satisfy.
实践结果表明采用工装保护电阻炉加热淬火后的零件硬度及强度满足技术要求。
4·The fuel used for heating is either blast furnace gas or coke oven gas. The combustion air is always preheated to improve fuel utilization.
用来加热的燃料不是高炉煤气就是焦炉煤气。燃烧用风通常要预热，以提高燃料的利用率。
5·Have gathered heating, floor heating, air conditioning, heating Wall hanging furnace river north by now.
现在北方人选用的干流采暖方法有会集供暖、地暖、壁挂炉、空调。
6·During the simulation of the dynamic properties of regenerative high temperature air combustion system in coupled case, an industrial heating furnace model is selected as the physics model.
在对耦合工况下蓄热式燃烧系统的动力特性分析中，以一个工业用蓄热式加热炉为参考计算模型。
7·The heat pipe failure, lower heating air temperature, higher flue gas emission of the furnace in operation are analyzed and improvement measures are suggested.
对实际运行中存在的热管失效、热空气温度偏低、排烟温度偏高等问题进行了分析，并提出了相应的改进措施。
8·The important role as played by the air preheater for energy saving of the steel tube heating furnace is discussed.
阐述了钢管加热炉使用空气预热器节能的重要性。
9·The tunnel furnace is designed as a channel type, the drying tunnel furnace is heated by the stainless steel heating pipe and the hot air circulation is carried out by using the 3 typhoon machine.
隧道炉设计为通道式，烘干隧道炉为不锈钢加热管升温并使用3台风机进行热风循环。
10·The topic is proposes according to requirement of Panzhihua New Steel Vanadium Co in the situation of equipment management and safety of Heating furnace combustion air blower.
课题是根据攀枝花新钢钒股份有限公司热轧板厂设备管理状况和加热炉助燃风机的安全需要提出的。