1·Cut all the blocks up on the band saw.
削减所有拦截高达对带锯。
2·Using a band saw cut the piece in half as shown.
使用带锯削减一半的一块，如图所示。
3·Next cut out on the outside of the lines with a band saw.
其次删去在线的外部与带看见了。
4·Deep Cut Band Saw has a front T-handle for better control.
深切割带锯有一个前置T型手柄，能更好地进行控制。
5·I used a band saw, a table saw and a miter saw for these cuts.
我用一带锯，看到一张桌子和一个字看到这些削减。
6·Cut and buff tyre sections using a band saw and bench grinder.
用锯条切割轮胎断面并磨平断面。
7·Vertical band saw. Dimensions and operating clearance area can be specified.
立式带锯。可以指定尺寸和操作净空面积。
8·This article introduces how to make the band saw sensor of measured shearing force and its structure.
文中介绍了带锯切削力传感器的结构、制做方法。
9·This paper introduces the processing theory of MJKS365 numerical control (NC) woodworking curve band saw.
介绍了研制开发的MJKS365型数控木工曲线带锯机的工作原理。
10·NC curve saw computer aided program system is a automatic program system which applied to NCcurve band saw.
数控曲线锯计算机辅助编程系统是为数控曲线带锯机而配套的自动编程系统。
1·General circular saw, band saw and handsaw etc all can use, also can use portable chainsaw, careful cutting plate is slower, prevent the broken plate.
一般的圆锯，带锯和手锯等都可以运用，还可以用便携式电锯，留神裁剪板材的是要要慢，防止弄坏板材。
2·Vertical band saw. Dimensions and operating clearance area can be specified.
立式带锯。可以指定尺寸和操作净空面积。
3·I used a band saw, a table saw and a miter saw for these cuts.
我用一带锯，看到一张桌子和一个字看到这些削减。
4·Cut all the blocks up on the band saw.
削减所有拦截高达对带锯。
5·Before we can make the pressurized board sawed and shaped first we should put the tailor-made cyclostyle on the timber and draw the shape then saw the shapes using the small band saw.
要将拼压好的板切锯成型，首先将特制的模板放在木料上划出形状，然后用小带锯进行切锯。