1·It can satisfy the requirement of base band data transfer.
可以满足基带数据传输的要求。
2·Chapter 4 is about the digital front end design of base band system.
第四章介绍了数字基带系统设计中数字前端设计。
3·Following the RX signal path, low noise amplifiers, mixer topologies and base band filters are presented.
跟随着RX信号路径，我们会依次讲解低噪声放大器，混频器拓扑和基带滤波器。
4·The demo system herein consists of three parts: base band transmitting board, baseband receiving boards and MPU board.
实验验证系统由基带发送、基带接收、主控三部分构成。
5·The purpose of this paper is to meet this need, that is to design a base band signal generator based on WCDMA downlink.
本论文的目的就是设计一个基于WCDMA下行链路的基带信号发生器。
6·This article has designed an elliptic low pass filter for the generation of base band signals in a wideband chirp source.
对宽带线性调频源中基带信号产生时所用的低通滤波器进行了设计。
7·AIS system is composed with communication processing module, base band processing module, radio module and interface module.
AIS系统由通信处理模块、基带处理模块、射频模块和接口模块组成。
8·This paper reports two computerized methods for decoding the digital base band signal obtained from meteorological satellite.
论述利用计算机对气象卫星数字基带信号解码的两种方法。
9·Typically the interface between these devices (the radio and the base band processor) is an analog in-phase and quadrature (I and q) link.
通常这些器件(射频和基带处理器)间的接口是同向和正交(I和Q)链路。
10·Since the CMOS technology used in the part of base band design is relatively very mature, it is unreasonable to change the technology of base band.
由于基带部分的CMOS工艺相对来讲已经比较成熟，改变基带部分工艺的可能性和可行性不大。
1·AIS system is composed with communication processing module, base band processing module, radio module and interface module.
AIS系统由通信处理模块、基带处理模块、射频模块和接口模块组成。
2·In WCDMA system, downlink base band modulation involves a lot of channels and complex functions, resulting in prolonged time and higher costs for test and verification.
WCDMA中下行链路基带调制信道多，功能复杂，对其测试和验证所花费的时间和费用也随之提高。
3·This paper reports two computerized methods for decoding the digital base band signal obtained from meteorological satellite.
论述利用计算机对气象卫星数字基带信号解码的两种方法。
4·Typically the interface between these devices (the radio and the base band processor) is an analog in-phase and quadrature (I and q) link.
通常这些器件(射频和基带处理器)间的接口是同向和正交(I和Q)链路。
5·Following the RX signal path, low noise amplifiers, mixer topologies and base band filters are presented.
跟随着RX信号路径，我们会依次讲解低噪声放大器，混频器拓扑和基带滤波器。