1·Resistor R3 allows IC1 to drive the capacitive load that C1 presents without going into oscillation.
电阻r 3允许IC 1来驱动电容负载，使C1不会进入振荡状态。
2·Ac load bank has kinds of specifications and series, and include resistance, inductive and capacitive load.
交流负载箱有各种规格，系列齐全。有纯阻性负载或阻性、感性、容性负载。
3·This paper introduces a design method and circuit of power supply with high voltage and high frequency response for driving capacitive load.
本文介绍了一种可带容性负载的高电压、高频响激励电源的设计方法及相应的实现电路。
4·The switching circuit is offen used in the pulse digital system. As the switching circuit is acted on by capacitive load, the working speed of the switching circuit is limited.
开关电路是脉冲数字系统中常用电路之一，由于负载电容的影响，限制了该电路的工作速度。
5·This paper describes the mechanism that multiple reignition of breaker can restrain or increase progressively the switching overvoltage during switching off inductive or capacitive load.
论述了开关在开断感性或容性负载时多次重燃对过电压的抑制或递升机理。
6·At the same time, constitute a capacitive load, so that capacitive power factor of 0.2 to a minimum the following, non-harmonic and electromagnetic interference, the true green light source.
同时，构成电容性负载，使容性功率因数降至最小0.2以下，无谐波和电磁干扰，真正的绿色光源。
7·The methods used to limit transient effects depend on whether the load is capacitive or inductive.
限制瞬态效应所使用的方法取决于负载是电容性的还是电感性的。
8·The voltage ripple waveform is analyzed based on the inductance and the capacitive change under two load models.
在两种负载模型下，通过计算分析了滤波电感和电容对电源电压波动的影响；
9·Buffer amplifier An amplifier, usually in a gain of 1 or 2, used to drive a heavy capacitive or resistive load.
缓冲器放大器一种放大器，通常可以放大1到2倍，用于驱动大容量或大阻抗负载。
10·Shunt reactor could be installed in the middle segment of the UHV transmission line, in order to compensate capacitive current of transmission line and limit over-voltage of line without load.
特高压长线路可能在线路中间接入并联电抗器，从而有效补偿线路电容电流，抑制空载线路过电压。提出了在特高压长线路中间带并联电抗器时的线路分相电流差动保护原理。