1·In process, the surface accuracy is affected by motion parameters such as discharging current capacity and current impulse width.
在加工过程中，加工表面精度自然受到加工参数的影响，其中包括放电电流能量、电流脉冲宽度等的影响。
2·The charging and discharging currents are controlled by the current flowing into IIN, and are modulated by the voltages applied to FADJ and DADJ.
充放电的电流是由流入IIN端的电流来控制的，并由加到FADJ和DADJ上的电压调制。
3·Low voltage charging or discharging may also cause deterioration of capacitor such as shorting and open due to sudden charging and discharging current.
即使是低电压充放电，也可能产生大的瞬间充放电电流，这可能会导致电容器性能的损害，比如说短路或开路。
4·The phenomenon of discharging in twice of underwater wire exploding is discovered by investigating the time characteristics of pulsed discharging current and voltage.
通过测量水中铜丝电爆炸的电流、电压波形发现水中高压放电存在着二次放电现象。
5·Through the experiments with quickly wire cut of electric discharge machines, this paper analyzes and studied the influence regulation of the discharging current to the surf...
通过在快走丝线切割加工机床上进行多次加工实验，本文研究分析了放电电流对线切割加工表面粗糙度的影响规律。
6·When it is discharging, the ions flow back and in the process cause a current to flow in an external circuit attached to the battery.
放电时，离子回流，这个过程中会在连接到电池的外部电路中产生电流。
7·Discharging prior to BREAK-IN mode is optional. Overcharging during the BREAK-IN mode does not harm battery as the charging current is very slow.
在使用BREAK - IN模式前先给电池放电是可以的。在BREAK - IN模式下对电池过充不会对电池造成伤害，因为充电电流非常小。
8·Charging speed will be improved through depolarization by first-phase intense current charging and reverse discharging method.
通过一阶段大电流充电和反向放电去极化，有效提高了充电速度。
9·Arc current reducing rate and arc voltage at the time of arc discharging are established for every mathematical model.
得到电弧放电瞬间每一模型下的电流变化率和电弧电压。
10·The experimental investigation about some hydraulics problems on cooling water discharging in current cooling technique was studied in the article.
本文针对直流冷却方式中冷却水排放相关水力学问题进行试验研究。