1·In order for the flange joint to maintain a gasket seal.
为使法兰连接保持良好的垫片固定密封。
2·An exact elastic solution for the general case of a circular flange joint under tension loading is derived.
文中推导出一般情况下圆形螺栓法兰接头的弹性解，这一解可被应用于不同类型的接头上。
3·If there is leakage at the flange face-seal only, further tightening of bolts will almost never stop any flange joint leak.
如果泄露仅仅出现在法兰面密封上，进一步的螺栓紧固基本上并不会阻止法兰连接部分的泄漏。
4·The paper describes the common structure and some existing problems of flange joint on mill's cylinder, and the influence on manufacture organization.
较详细论述了磨机筒体缗法兰联接常见结构及存在问题，以及对生产组织的影响。
5·In recent years, owing to the great number of flange joints and complexity of work condition, the failure rate of flanged joint system is increasing continuously.
近年来，由于法兰连接系统数目的增加、工况条件的复杂性，法兰连接系统的故障率也不断的上升。
6·The method of surfacing welding sealing strip was adopted to repair the deformation of the flange joint surface of the high and intermediate pressure outer casing .
修理前，围绕兼顾解决焊接性、应力和变形问题，结合实际施工条件制定了以手工钨极氩弧焊、镍基焊丝、焊前低温预热、焊后锤击焊缝为要素的冷堆焊工艺。
7·Under certain pre - tension from flange joint bolt, leakage of flange sealing had an obvious decrease, thus resolving sealing failure in cover flange of heat exchange.
在一定法兰连接螺栓预紧力作用下，法兰密封泄漏明显减少，从而解决了热交换器封头法兰密封失效的问题。
8·Force transfer mechanism of the vertical stiffener joint model with only tensile beam flange is analyzed.
本文对外肋环板节点梁翼缘受拉模型的传力机理进行了分析。
9·Its flange USES the bolt joint.
其法兰处采用螺栓联接。
10·It is composed of casing flange, casing cross joint, wellhead valves, tubing hanger, tubing head cross joint and accessories.
这种井口装置由套管法兰、套管大四通、井口阀、油管挂、油管挂体及相关附件组成。