1·The centralized control device for set includes port for inputting measured signal from sensor.
机组集控装置设有传感器测量的 信号输入端口；
2·The noise in the measured signal is constrained to "white" noise or at least nearby "white" noise.
这要求被测信号中的噪声为白噪声或至少接近白噪声。
3·The sensitivity of a measurement is the smallest change of the measured signal that can be detected.
测量的灵敏度是可以探测出的被测信号的最小变化量。
4·In the process of microwave measurement, adjusting the level of the measured signal is an important part.
微波测量过程中，对不同电平的被测信号进行电平控制，是测量过程的重要步骤。
5·The resulting offset voltage is subsequently subtracted from the measured signal to maximize measurement accuracy.
随后从被测的信号中减去测量出的偏置电压，以便最大限度地提高测量的准确度。
6·Using the principle of the reference signal being uncorrelated to the measured signal, the latter could be extracted easily.
利用噪声信号与参考信号不相关的原理，有效地提取微弱被测信号。
7·The measured signal needing by system popularly can be divided into two kinds which are on-off quantity and analogy quantity.
系统需要的被测信号，一般可分为开关量和模拟量两种。
8·This paper particularly analyze the relation between frequency of measured signal and frequency of count pulse on measuring precision.
文中详细地分析了被测信号的频率和计数脉冲的频率与测量精度之间的关系。
9·For the factors of bearing using conditions, installation, and load, etc., the measured signal is often mixing with a variety of interference signals.
又因为轴承的使用状况、安装的情况和载荷等等因素，测得的信号往往是含有多种的干扰信号。
10·Results: the results showed that the measuring electrode, skin-electrode, contacting impedance, and stimulating frequency all influenced the measured signal.
结果：电极阵列、电极皮肤接触阻抗、激励频率均对检测信号有影响。