1·Make a tensile test.
做拉伸试验。
2·Layered fracture occurs after tensile test of high strength ship plate.
高强船板拉伸试验后出现断口分层现象。
3·The failure assessment diagrams were derived from the tensile test results.
评定根据母材和全焊缝拉伸试验结果建立评定曲线；
4·The factors of the tensile test of carbon fibers were discussed in this paper.
本文讨论了碳纤维强伸实验的影响因素。
5·The single tensile test of low carbon steel is an important content of mechanics tests.
低碳钢的单向拉伸试验是力学试验的一项重要内容。
6·The fracture surface appeared intergranular crack, due to the oxide formed during tensile test.
拉伸过程中形成的氧化物夹杂成为裂纹源，断口表现为沿晶断裂。
7·The result of insitu-tensile test shows that the behavior of fracture is transcrystalline rupture.
扫描电镜下的原位准静态拉伸试验表明，合金的断裂行为是穿晶韧性断裂。
8·It is found that the weld of fine grain steel break apart from heat effect zone in the tensile test.
经实验发现细晶粒碳钢焊接接头拉伸试验断口在远离热影响区的母材上。
9·This paper discusses the fracture shape of the tensile test sample in practice teaching of mechanics.
本文就力学实践教学中拉伸试样断口形状问题进行探讨。
10·Before completing linkage screw in the machining, finished products are needed to do the pre-tensile test.
连杆螺钉在加工完成后成品交验前，要求进行预拉伸试验。