1·Vortex flow meter, pressure sensor and thermal couple are installed on the platform.
新的实验台增加了压力传感器、涡轮流量计和热电偶等自动测量传感器和仪表。
2·Thermal couple must be continuous from the measured device to the digital thermometer.
热电偶必须连续的连接在测量设备与温度计中。
3·The probe of typical steels has specific features in measurement, material, thermal couple arrangement, etc.
常用钢热探头在尺寸、材料、热电偶布置等方面不同于以往的评价方法中使用的热探头。
4·Thermometer is used for temperature measurement. In most case a digital thermometer plus K-type thermal couple is used.
温度表用来测量温度。大多数的数字温度表都配用K型的热电偶。
5·If the measure device is small, the heat conduction effect of thermal couple significant, measured temperature will be lower.
如果测量设备很小﹐热电偶的热传导效应显著﹐则测量的温度会较低。
6·The physical behavior of fluid film interface characterized by a fluid-solid-thermal couple model is described particularly.
针对使用流体-固体-热耦合模型的油膜特性分析方法进行了详细说明。
7·The combustion wave temperature profiles and flame structures of fuel-rich propellant containing boron are measured by using W-Re micro-thermal couple and flame photo technique.
通过微热电偶测温和火焰单幅照相技术测试了含硼富燃料推进剂燃烧波温度分布及燃烧火焰结构；
8·The design method of on-line shell temperature measuring system is introduced in this paper. It is emphasized to measure shell temperature with thermal couple and ADAM module here.
介绍了铝电解槽壳温度在线检测系统的设计方法，重点讲述了如何应用热电偶和ADAM模块进行温度采集和传送。
9·When an electric heating method is used for heating, thermal couple and heating coil should be installed closest to the bevel while should not hinder the access of welder to the joint.
采用电加热法加热时，需注意热电偶及加热圈的安装要尽可能靠近坡口，但不得妨碍焊工接近接头。
10·Braun notes that for people who handle only a couple of receipts a day, thermal paper is unlikely to be a major source of exposure.
布劳恩强调人们一天顶多接触很少几张打印凭据，热敏纸不可能是接触双酚A的主要来源。
1·Thermal couple must be continuous from the measured device to the digital thermometer.
热电偶必须连续的连接在测量设备与温度计中。
2·When an electric heating method is used for heating, thermal couple and heating coil should be installed closest to the bevel while should not hinder the access of welder to the joint.
采用电加热法加热时，需注意热电偶及加热圈的安装要尽可能靠近坡口，但不得妨碍焊工接近接头。