1·The influence of the thermal isolation of the PS on resistance's sensitivity of VOx film was investigated.
并在其表面沉积了氧化钒热敏薄膜，研究了多孔硅样品的热绝缘性能对氧化钒热敏薄膜阻温特性的影响。
2·The sensor (10) also includes a cavity formed under the diaphragm layer (16) and is configured to provide thermal isolation of the heating element.
传感器（10）还包括形成于隔膜层（16）下面 的空腔，并配置成提供加热元件的隔热。
3·Porous silicon has been used broadly in the fields of micro-sensors because of its special thermal isolation performance and advantages in technology.
多孔硅由于其热绝缘特性以及技术优势，已经在微传感器领域得到广泛的应用。
4·Instead of surface sacrificial layer and bulk micromachining technique, using polymer as thermal isolation material decreases cost and improves yield.
以聚合物材料作为绝热材料，避免了表面牺牲层工艺和体加工技术，降低了成本、提高了成品率。
5·This paper describes the classical mathematic model of bolometer, the effect of thermal isolation and noise on detector performance are also discussed.
总结了非制冷测辐射热计的经典数学模型，并分析了探测器热绝缘结构和噪声对性能的影响，指出了性能改进和优化的基本途径。
6·Analysis of the simulation result attests that the thermal isolation structure is important in the design of a bolometer detector thus endorsing the present work.
仿真结果分析证明了热绝缘结构在探测器设计中是占有重要地位的，同时说明本文所做工作是有意义的。
7·This paper put forward application modes, cautions, and the effect of use of vacuum thermal isolation plate in refrigerator. The prospect of vacuum thermal isolation plate was described.
指出了真空隔热板在电冰箱隔热保温中的应用方式、注意事项及使用效果，展望了真空隔热板的应用前景。
8·This article intorduces briefly a new kind of composite which has a lot of advantages such as wear-resistance, thermal isolation, corrosion resistance, high strength, and light weight, etc.
新型复合材料具备耐磨损、隔温、防腐蚀、强度高、重量轻等多种优点，是现代交通工具上应用的理想材料。
9·In addition to controlling mechanical shaft and bearing loads, the coupling further protects the encoder by providing a high degree of electrical and thermal isolation between coupled shafts.
除了控制的机械轴和轴承载荷，耦合进一步保护通过提供电力和热轴之间的耦合隔离高度编码器。
10·The support straps system of spaceborne radiant coolers requires thermal isolation and it requires to remain high stiffness and strength in order to ensure the radiant coolers structural integrity.
星载辐射制冷器的级间支撑，即要隔热，又要求保持一定的刚度和强度，保证辐冷器结构的完整性。