1·To support the principle of triangulation, etc., the rolling process, the workpiece can improve roundness, concentricity, perpendicularity.
以等三角支撑原理，进行滚压加工，可提高工件真圆度、同心度、垂直度。
2·If the coupling vibration or bearing position is high temperature, readjust the concentricity of the coupling or bearing is lack of oil.
如联轴器振动或轴承位发热，应重新调整联轴器的同心度或轴承是否缺油。
3·Plus the motor shaft axis, concentricity absolutely right and reliable.
泵轴为电机加长轴，同心度决对可靠。
4·The key technical problems of the bond strength between the matrix and steel body, the concentricity and diamond segments sealing off from the body are successfully resolved in the studies.
本研究成功地解决了胎体与钢基体结合强度、同心度及金刚石掉块等关键技术问题。
5·Professional processing make the surface finish of the product to above 1.6, the tolerance is within 0.02mm, concentricity is 0.005mm.
专业的加工使产品表面光洁度可达到1.6以上，尺寸精度可保证在0.02 mm以内，同心度0.005 mm。
1·Both POD and EST techniques could be used for identifying the species of Poa, but POD technique is superior to EST technique in stability, feasibility and band concentricity.
EST两种技术都可用于对早熟禾属物种的辅助鉴定，但POD技术在稳定性、酶带集中性和可操作性方面优于EST技术。
2·Because of the limit of extent of short story, Li intensified the narrative emphasis by adjusting speed of narration, which resulted in ensureness of integrality and concentricity in the works.
在短篇小说篇幅有限的情况下，叙事者通过调整叙事速度突出叙事重点，由此同时兼顾到了叙述的完整性和集中性，形成良好的叙事效果。
3·With regard to L1 mental lexicons, Chinese English learners have poorer concentricity of association and weaker association strength.
与母语者相比，中国英语学习者的联想集中性较差，联想强度较弱；
1·Obviously, this can significantly improve the claw after processing the inner circle and the spindle concentricity and eliminated the phenomenon, to obtain high precision, to modify the purpose.
显然，这样就能明显提高加工后的卡爪内圆与机床主轴的同轴度并消除喇叭口现象，获得较高的精度，达到修正的目的。
2·This kind of bearing outer ring raceway is spherical shape, so the self-aligning good performance, to compensate concentricity error.
该类轴承外圈滚道是球面形，故其调心性能良好，能补偿同轴度误差。
3·Because of the locating error of the part, it is difficult to assure the concentricity between the two holes.
由于存在定位误差，两孔之间同轴度很难保证。