superheat
英音[ suːpəˈhiːt; sjuː- ] 美音[ ˌsjʊpəˈhit ]

过热

常用释义

词性释义

v.

(使)(液体)过热;加热(气体)到饱和温度以上;把……加热到高温

n.

(气体的)过热
例句
  • 全部
  • 过热
The results show that the degree of wall superheat increases as the inlet velocity decreases and the heat flux increases.
结果表明,壁面过热度随流速的增大而减小,随热流密度的增加而增大;
本发明涉及一种海参或鲍鱼真空过热蒸汽干燥系统及其工艺。
However, excessive P addition results in a larger degree of superheat of the melt, hence aggravating the oxidation.
但当P过量时,则会因熔体过热倾向明显而加剧氧化;
Moreover, superheat will last a shorter time with the heat load increasing.
其次,热流密度越大,过热时间维持的越短;
Along with the increase of melt superheat time, the primary dendrite arm spacing decreases and the microstructure is refined.
随着熔体过热时间的延长,一次枝晶间距减小,组织越来越细密;
It is shown that the initial microstructure and texture of cast strips can be controlled by changing superheat in the melt pool.
研究结果表明:在薄带连铸条件下,通过调整熔池内钢水的过热度可以实现对薄带坯初始组织、织构的有效控制。
加湿系统HumidificationSystem表面蒸发式,附加湿器缺水断电及过热保护。
对于某个特定体系来说,提高过热度会增加铝的溶解度。
在此基础上还模拟了不同过热度下铸坯的凝固组织。
Sir, you can have Lots of Heat, even More Heat, Superheat, Mega Heat, White Heat, a Little Heat or No Heat.
先生,我们可以有很多热,更多热,超级热,巨热,白热,一点热或不热。
The higher the rotation speed of the turnplate and the degree of superheat, the more finer the particle size.
转盘转速越高,金属熔体过热度越大,活化粉体粒径越细。
结果表明:经冷却辊冷却的钢液过热度降低,实现了低过热度浇铸的目的。
Some technical ideals to manage the aluminum reduction cell with low superheat degree are put forward.
提出了低过热度管理铝电解槽的技术思路。
如果你这样过分加热的话,这容器会爆炸。
The effect of the superheat is much slighter than that of above mentioned factors.
与上述因素相比,过热度的影响很小。
It will not superheat the floor.
不会使地面过热。
The paper summarizes the study and some applications in the field of melt superheat treatment.
简述了国内熔体过热处理的研究;
现在,我国政府对房地产市场局部过热和“泡沫化”倾向作出了足够的重视。
硬度法预测锅炉高温管道的剩余寿命
发电厂锅炉高温炉管剩余寿命综合评估
热保护器温度特性检测系统的研制
微乳液的制备及其过热极限的测定
每个回路的排放和抽吸饱和?温度和过热
考虑壁温控制的过热汽温自动控制系统设计与投运
连铸拉速和中包过热度的耦合作用分析及二冷配水控制实现
电厂过热汽温控制系统的改进及其PID鲁棒整定
电子膨胀阀调节蒸发器过热度的控制算法
串级调节在过热蒸汽温度控制中的应用
Further analysis of the effect on the refrigeration coefficient with the superheat of the refrigeration cycle
制冷循环的过热对制冷系数影响的探讨
浸出油厂使用过热水蒸汽的利弊分析
1·The experience was conducted using cooling slope and low superheat processes, effects of pouring temperature and the degree of slope on the billet's structure were researched.
采用激冷斜槽法和低过热法进行浇注料坯的试验,在试验中研究了不同浇注温度和冷却板倾斜角度对所浇注料坯的微观组织的影响。
2·For the security and economic of power plant, research the new control method which can overcome the disadvantages of traditional superheat steam temperature control system has important meaning.
研究能克服传统过热汽温控制系统的缺点的新型控制方法,对于电站运行的安全性和经济性有十分重要的意义。
3·Some problems as incorrect adjustment on the degree of superheat, general failure of the thermometer bulb, matching of the capacity and freezing of the TEV are presented.
介绍了热力膨胀阀应用于空调制冷系统的几个问题:过热调整不当、感温包常见故障、容量匹配及膨胀阀冻结故障等。
4·Lastly the adaptive fuzzy control method proposed in the paper is applied to control the superheat steam temperature of the boiler, and the practical control effect is satisfactory.
论文最后将文中的自适应模糊控制方法应用到锅炉过热蒸汽温度控制中,取得了良好的控制效果。
5·Based on the experiments, the variation rule of the sensitive physical properties of AlSi alloy melt was studied under the conditions of modification and superheat.
本文在试验基础上研究了铝硅合金熔体在变质和过热条件下敏感物性的变化规律。
常用短语
degree of superheat
degree of superheat - 过热度;过热程度
同义词
n.