1·"Tech is designed to really suck you in," says jenny Radesky in her study of digital play, "and digital products are there to promote maximal engagement."
詹妮·拉德斯基在她的数字产品研究中宣称：“发展科技的目的就是为了让你沉浸其中，生产数字产品是为了促进最大的参与度。”
2·Technically, a gap is a maximal sequence of contiguous Spaces.
从技术上讲，间隙是最大的连续空格序列。
3·The authors also point out that cycles of maximal productivity and deep recovery allow for consistent and continuous usage of our full capacity.
作者还指出，最大生产力和深度恢复的循环使我们可以持续不断地满负荷使用精力。
4·A good example to illustrate this is the maximal number of connections to the BPEDB.
说明这点的一个很好示例是到BPEDB的最大连接数量。
5·Solar panels that can shake off their dust off via a self-generated electric pulse keep soaking in maximal rays.
太阳能电池板能通过自发电脉冲震落其灰尘，以确保最大限度的获得光照。
1·The study proved that laminated winding process could effective take advantage of composite material and increase the maximal speed of composite flywheel rotor for energy storage.
研究结果表明采用分层结构工艺，可有效利用飞轮材料的性能，进一步提高复合材料储能飞轮的最高转速。
2·Finally, experimental study is carried through a bionic nose system, and the maximal identification rate achieves 100%.
最后用研究的仿生鼻对白酒进行了实验研究，最高识别率达100%。
3·The volume fraction of carbon monoxide in product gas is about 1%, the volume of methane is in excess of 10% and the maximal volume fraction of hydrogen reaches to 41.28%.
在相同的实验条件下不同生物质气化得到了相似的气体组分，气体产物中一氧化碳体积分数大约为1%，甲烷体积分数超过10%，氢气的体积分数最高可以达41 28%；
4·Objective: To estimate the dietary selenium requirement for the maximal rates of glutathione peroxidases synthesis in rats.
目的测定大鼠谷胱苷肽过氧化物酶活性达到最高时所需的饲料硒水平。
5·Results: The normal ventricle had optimal stroke work, minimal total energy and end systolic potential energy with maximal energy efficiency.
结果：正常心室有最适搏出功，总能量和收缩末势能最低而能量效率最高。
1·The maximal limitation for noise outburst at night should not exceed15 db.
夜间突发的噪声，其最大值不准超过标准值15分贝。
2·The results show that the stress in ceramic layer is mainly for lateral compressive one, and its maximal stress occurs in the place that is at the distance of 1/3 thickness from coating surface;
结果表明，陶瓷层内的残余应力主要表现为横向压缩应力，且最大值位于距陶瓷层表面1/3厚度处；