1·AAA should be enabled on the router.
AAA 在路由器上应该被启用。
2·As you can see, the NAT router stores the IP address and port number of each computer in the address translation table.
正如你所见, NAT 路由器将每台计算机的 IP 地址和端口号都存储在地址转换表中。
3·If you need to pass the message to a second service for additional processing, you would configure an outbound router on the first service to pass the message to the second service.
如果为了进一步处理消息,需要将消息传递给第二个服务,那么需要在第一个服务上配置一个出站路由器将该消息传递给第二个服务。
4·This can cause problems if there is not enough disk space to transfer the message or if your company USES router controls to limit the size of messages sent in the environment.
如果没有足够的硬盘空间来传递消息,或者您的公司使用路由器控制来限制在环境中发送的消息的大小,那么这会造成问题。
5·As I don't have every router available to test with, I can only give you general directions in this area.
因为我不可能去测试每个路由器,所以我只能在这方面给你一个通用的方向。